e e - - p p h h e e m m t t m m m m i i c c a a e e 4 4 1 1 4 4 (preliminary) ? tel : 82-31-250-5011 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 product features application ? small size (3x3 mm) ? higher gain ? higher linearity ? dfn smd type package ? higher productivity ? lower manufacturing cost ? -60dbc cso 135 channels @ +30dbmv/ch ? -71dbc ctb 135 channels @ +30dbmv/ch ? -71dbc xmd 135 channels @ +30dbmv/ch ? low noise figure ? low noise amplifier for catv, satellite ? cable modem ? ftth (g-pon, ge-pon) ? optical node description AE414 is designed as low cost driv e amplifiers for many applicati ons including ftth, catv system. this mmic is based on gallium arsenide enhancement mode phemt which shows low current draw and very low noise. the data in this spec sheet is valid only for 75 ohm app lication. 50 ohm data is in a separate spec sheet. specifications parameter unit min typ max condition frequency mhz 50 ~ 2200 gain db 18.5 20 input return loss db -20 output return loss db -10 output ip3 dbm 35 38 1db compression point dbm 22 25 noise figure db 2 2.5 cso dbc -60 -55 135 channel, +30dbmv/ch ctb 30 ~ 870mhz dbc -71 -66 135 channel, +30dbmv/ch xmod dbc -71 -66 135 channel, +30dbmv/ch dc current ma 140 vdd = 8.0v absolute minimum and maximum ratings parameter unit min typ max device voltage vdc +8 +8.5 operating temperature -40 +85 storage temperature -40 +150 note 1. test conditions unless othe rwise noted. 1000mhz, t=25 , vdd= 8v, 75 ? system 2. oip3 measured with 2 tones at an output power of +10dbm/tone separated by 1mhz package : dfn
e e - - p p h h e e m m t t m m m m i i c c a a e e 4 4 1 1 4 4 (preliminary) ? tel : 82-31-250-5011 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 application circuit: 50~ 2200mhz, 8v, 75ohm system 1 AE414 100 nf 2.2 nh input 100 nf 3.9 nh output 680 ? 10 nf 3.3 nh 82 ? 0 ? 820 nh (wire wound) +8 v 4.7uf / 16v (tantalium) 10 nf 680 ? 2 3 4 8 7 6 5 0.3 pf multi-tone test 135ch_flat@output power +30dbmv level: +30dbmv tilt: 135ch_flat 8v 680 ohm frq xmd(ncta) ctb_raw ctb_cor n-flr csu_raw csu_cor csu_frq csl_raw csl_cor csl_frq 55.25 73.2 75.2 79.6 76.5 76 80.4 56.06 72.4 74.6 53.99 77.25 74 75.6 80 76.5 72.6 74.8 77.99 76 80.4 75.89 109.25 74.2 74.8 79.2 76.3 75.9 80.2 110 71.5 73.1 107.99 211.25 73.4 74.9 79.3 76.1 75.5 79.8 212.49 69.9 71 209.99 331.25 73.5 73.5 77.8 74.9 71.4 73.9 332.5 67.1 68 329.99 445.25 72.5 74.5 78.8 76.1 69.3 70.3 446.5 66.1 66.6 443.99 547.25 71.9 73 77.3 73.9 65.6 66.3 548.5 64.5 65 545.99 637.25 72.3 73 77.3 74.4 64.1 64.5 638.49 65.7 66.3 635.98 745.25 71.9 72.9 77.2 74 61.8 62.1 746.49 68.3 69.7 743.98 859.25 71.5 71.4 75.7 72.1 60 60.3 860.49 70.3 74.6 858.49 min 71.5 71.4 75.7 72.1 60 60.3 56.06 64.5 65 53.99 max 74.2 75.6 80 76.5 76 80.4 860.49 76 80.4 858.49 frequency (ghz) s-parameter frequency (mhz) noise figure pcb material (fr4), pcb thickness (0.8t), via hole ( 0.4) 0 1 2 3 4 5 6 10 400 800 1200 1600 2000 2400 nf (db) 0.5 1.0 1.5 2.0 0.0 2.5 5 10 15 20 0 25 -10 0 10 -20 20 return loss (db) gain (db) s21 s11 s22
e e - - p p h h e e m m t t m m m m i i c c a a e e 4 4 1 1 4 4 (preliminary) ? tel : 82-31-250-5011 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 application circuit: 50~ 2200mhz, 5v, 75ohm system 1 AE414 100 nf 2.2 nh input 100 nf 3.9 nh output 560 ? 10 nf 1.8 nh 51 ? 0 ? 820 nh (wire wound) +5 v 4.7uf / 16v (tantalium) 10 nf 2000 ? 2 3 4 8 7 6 5 0.3 pf multi-tone test 135ch_flat@output power +30dbmv level: +30dbmv tilt: 135ch_flat 5v 2 kohm frq xmd(ncta) ctb_raw ctb_cor n-flr csu_raw csu_cor csu_frq csl_raw csl_cor csl_frq 55.25 71.1 74.3 78.6 76.5 74.6 79 55.99 56.1 56.1 53.99 77.25 70.9 74.8 79.1 76 55.4 55.4 78 76 80.3 76.15 109.25 72.2 74 78.4 76.2 72.4 74.9 110 55.8 55.8 108 211.25 71.9 73.4 76.4 76.2 67.4 68 212.5 56.2 56.2 209.99 331.25 71.5 70.8 73 74.8 63 63.3 332.5 57 57 329.98 445.25 70.5 70.1 71.3 75.9 61.2 61.3 446.49 58.4 58.4 443.99 547.25 69.8 68.8 70.4 73.8 60.3 60.5 548.49 59.8 59.9 545.98 637.25 68.8 67.4 68.4 74.3 59.3 59.4 638.5 61.8 62.1 635.99 745.25 67.8 67.2 68.1 74.1 58 58.1 746.49 65.6 66.3 743.99 859.25 66.3 66.6 67.9 72.4 57.4 57.5 860.49 68.4 70.6 858.49 min 66.3 66.6 67.9 72.4 55.4 55.4 55.99 55.8 55.8 53.99 max 72.2 74.8 79.1 76.5 74.6 79 860.49 76 80.3 858.49 parameter unit typical data gain db 19 oip3 dbm 33 p1db dbm 19 cso dbc -53 ctb dbc -63 xmod dbc -63 dc current ma 100 0.5 1.0 1.5 2.0 0.0 2.5 5 10 15 20 0 25 -10 0 10 -20 20 return loss (db) gain (db) s21 s11 s22 0 1 2 3 4 5 6 1 0 4 00 800 12 00 1 600 2 000 24 00 nf (db) frequency (ghz) s-parameter frequency (mhz) noise figure rb 5v application, bias resistor(rb) 2 kohm *test condition: 1000mhz, 25
e e - - p p h h e e m m t t m m m m i i c c a a e e 4 4 1 1 4 4 (preliminary) ? tel : 82-31-250-5011 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 application circuit: 50~ 1000mhz, 8v, 75ohm system application circuit: 50~ 1000mhz, 5v, 75ohm system specifications parameter unit typical data condition frequency mhz 50~1000 supply voltage v 8 5 bias resistor ? 680 2 k rb gain db 21.4 21 oip3 dbm 39** 36*** p1db dbm 25 20 noise figure db 1.7 1.7 cso dbc -60 -53 135 channel, +30dbmv/ch ctb dbc -71 -63 135 channel, +30dbmv/ch xmod dbc -71 -63 135 channel, +30dbmv/ch dc current ma 140 100 0.2 0.4 0.6 0.8 1.0 1.2 0.0 1.4 5 10 15 20 0 25 -20 -10 0 10 -30 20 return loss (db) gain (db) 0.20.40.60.81.01.2 0.0 1.4 5 10 15 20 0 25 -20 -10 0 10 -30 20 return loss (db) gain (db) 1 AE414 100 nf 10 nh input 100 nf 6.8 nh output 910 ? 10 nf 0 ? 150 ? 0 ? 820 nh (wire wound) +8 v 4.7uf / 16v (tantalium) 10 nf 680 ? 2 3 4 8 7 6 5 1.5 pf s21 s11 s22 frequency (ghz) s-parameter rb s21 s11 s22 frequency (ghz) s-parameter rb note *. test conditions unless otherwise noted. 500mhz, t=25 , 75 ? system **. oip3 measured with 2 tones at an output power of +10dbm/tone separated by 1mhz ***. oip3 measured with 2 tones at an output power of +5dbm/tone separated by 1mhz
e e - - p p h h e e m m t t m m m m i i c c a a e e 4 4 1 1 4 4 (preliminary) ? tel : 82-31-250-5011 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 block diagram pin no description 1 bias control 2, 7 no connection 3 rf input 4, 5, 8 ground 6 rf output package dimensions (type: dfn 3 x 3 -8l) rfhic corporation (rfhic) reserves the right to make changes to any products herein or to discontinue any product at any time w ithout notice. rfhic do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, inclu ding without limitation consequential or incidental damages. the product specifications herein expressed have been carefully checked and are assumed to be reliable. how ever, rfhic disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase or ders. rfhic products are not intended for use in life support equipment or application where ma lfunction of the product can be expected to result in persona l injury or death. buyer uses or sells such products for any such unintended or unauthorized applicatio n, buyer shall indemnify, protect and hold rfhic and its direct ors, officers, stockholders, employees, representatives and distributors harmless against any a nd all claims arising out of such use. rfhic?s liability unde r or arising out of damages, claims of whatsoever kind and nature which rfhic p roducts could cause shall be limited in amount to the net p urchase p rice of the p roducts sold to bu y er b y rfhic .
|
